Certain Vertical Shaft Engines a Displaced, between 99 Cubic Centimeters and up to 225cc, and parts thereof

The merchandise covered by these orders consists of spark-ignited, non-road, vertical shaft engines, whether finished or unfinished, whether assembled or unassembled, whether mounted or unmounted, primarily for walk-behind lawn mowers. Engines meeting this physical description may also be for other non-hand-held outdoor power equipment, including but not limited to, pressure washers. The subject engines are spark ignition, single-cylinder, air cooled, internal combustion engines with vertical power take off shafts with a minimum displacement of 99 cubic centimeters (cc) and a maximum displacement of up to, but not including, 225cc. Typically, engines with displacements of this size generate gross power of between 1.95 kilowatts (kw) to 4.75 kw. Engines covered by this scope normally must comply with and be certified under Environmental Protection Agency (EPA) air pollution controls title 40, chapter I, subchapter U, part 1054 of the Code of Federal Regulations standards for small non-road spark-ignition engines and equipment. Engines that otherwise meet the physical description of the scope but are not certified under 40 CFR part 1054 and are not certified under other parts of subchapter U of the EPA air pollution controls are not excluded from the scope of these proceedings. Engines that may be certified under both 40 CFR part 1054 as well as other parts of subchapter U remain subject to the scope of these proceedings. Certain small vertical shaft engines, whether or not mounted on non-hand-held outdoor power equipment, including but not limited to walk-behind lawn mowers and pressure washers, are included in the scope. However, if a subject engine is imported mounted on such equipment, only the engine is covered by the scope. Subject merchandise includes certain small vertical shaft engines produced in the subject country whether mounted on outdoor power equipment in the subject country or in a third country. Subject engines are covered whether or not they are accompanied by other parts. For purposes of these orders, an unfinished engine covers at a minimum a sub-assembly comprised of, but not limited to, the following components: Crankcase, crankshaft, camshaft, piston(s), and connecting rod(s). Importation of these components together, whether assembled or unassembled, and whether or not accompanied by additional components such as a sump, carburetor spacer, cylinder head(s), valve train, or valve cover(s), constitutes an unfinished engine for purposes of these orders. The inclusion of other products such as spark plugs fitted into the cylinder head or electrical devices (e.g., ignition coils) for synchronizing with the engine to supply tension current does not remove the product from the scope. The inclusion of any other components not identified as comprising the unfinished engine subassembly in a third country does not remove the engine from the scope. Specifically excluded from the scope of these orders are ``Commercial'' or ``Heavy Commercial'' engines under 40 CFR 1054.107 and 40 CFR 1054.135 that have (1) a displacement of 160cc or greater, (2) a cast iron cylinder liner, (3) an automatic compression release, and (4) and a muffler with at least three chambers and volume greater than 400cc.