Common Alloy Aluminum Sheet

The merchandise covered by these orders is common alloy aluminum sheet, which is a flat-rolled aluminum product having a thickness of 6.3 mm or less, but greater than 0.2 mm, in coils or cut-to-length, regardless of width. Common alloy sheet within the scope of these orders includes both not clad aluminum sheet, as well as multi-alloy, clad aluminum sheet. With respect to not clad aluminum sheet, common alloy sheet is manufactured from a 1XXX-, 3XXX-, or 5XXX-series alloy as designated by the Aluminum Association. With respect to multi-alloy, clad aluminum sheet, common alloy sheet is produced from a 3XXX-series core, to which cladding layers are applied to either one or both sides of the core. The use of a proprietary alloy or non-proprietary alloy that is not specifically registered by the Aluminum Association as a discrete 1XXX-, 3XXX-, or 5XXX-series alloy, but that otherwise has a chemistry that is consistent with these designations, does not remove an otherwise in-scope product from the scope. Common alloy sheet may be made to ASTM specification B209-14 but can also be made to other specifications. Regardless of specification, however, all common alloy sheet meeting the scope description is included in the scope. Subject merchandise includes common alloy sheet that has been further processed in a third country, including but not limited to annealing, tempering, painting, varnishing, trimming, cutting, punching, and/or slitting, or any other processing that would not otherwise remove the merchandise from the scope of these orders if performed in the country of manufacture of the common alloy sheet. Excluded from the scope of these orders is aluminum can stock, which is suitable for use in the manufacture of aluminum beverage cans, lids of such cans, or tabs used to open such cans. Aluminum can stock is produced to gauges that range from 0.200 mm to 0.292 mm, and has an H-19, H-41, H-48, or H-391 temper. In addition, aluminum can stock has a lubricant applied to the flat surfaces of the can stock to facilitate its movement through machines used in the manufacture of beverage cans. Aluminum can stock is properly classified under Harmonized Tariff Schedule of the United States (HTSUS) subheadings 7606.12.3045 and 7606.12.3055. Where the nominal and actual measurements vary, a product is within the scope if application of either the nominal or actual measurement would place it within the scope based on the definitions set for the above.